149

The high temperature of the outlet of the melt pump is extremely unfavorable to the production process. So what are the reasons for the high temperature rise of the melt pump? The main faults of melt pump are: 1. pump does not turn 2. leakage materia

148

Introduction of rubber extrusion melt pump The rubber melt pump is used in the elastomer and the degradable plastic extrusion system. This type of pump adopts special internal structure and has high efficient self cleaning function. It is suitable fo

179

The gear pump is installed between the extruder and the machine head, so that the fluctuation caused by the extrusion direction can be isolated from the machine head and downstream equipment. No matter whether the pressure fluctuates at the entrance

187

Product introduction: M pulsation series is a general melt pump for extrusion system . It is mainly used for supercharging and stable flow transportation of extruder or high viscosity polymer, such as sheet, plate, pipe, film, cable, coextrusion, mix

129

1. check the fasteners of the melt pump daily, such as whether the screws are loose or not, check the installation of pipeline interfaces and so on. 2. check the oil seal clean, often need to clean the oil seal, to prevent the impact of the mechanica

80

The cause of the release of the coupling of the melt pump coupling 1.High load of melt pump So far, all the melt pump coupling tripping occurs when the load of the melt pump is above 110% of the design load. At the same time, compared with DuPont tec